Things to know before you begin: This is easy!

Vinyl decals are like a sandwich. In the middle of the sandwich is the vinyl. The top of the vinyl is covered with mask. The bottom of the vinyl is covered with non-stick paper.

Design Tip: When you receive your daisies, position them on your vehicle with a small piece of masking tape. Step back and rearrange the design until it pleases you. Then apply.

Before you begin: Clean the surface of the vehicle with a mild detergent or Windex and remove any dirt, oil or wax. Dry completely.

On a small daisy

Peel off non-stick paper
Apply directly to the vehicle
Smooth with the squeegee (included with every order)
Very slowly peel off the mask, pulling straight down

Hints : Apply your decals between 60-85° Fahrenheit (16-29° Celsius), out of direct sunlight. After application, if there is an air bubble in the graphic, there are three things you can do. First, leave it alone. The sun makes most bubbles disappear in a week or two. Or you can warm the bubble with a hair dryer, making it enlarge slightly, then prick it with a needle and watch it pop and lay flat. Or puncture the bubble with a needle and smooth it down.

On a large daisy

Mask top of daisy to vehicle
Lift up the underside
Peel away the upper half of the non-stick paper
Smooth Press down upper half, working top to bottom, then smooth down lower half
Smooth with squeegee, then very slowly peel off the mask, pulling straight down